Invacare ITFM - Manual

Part No 1141447 1 InTouch™ Flovair Seat
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
InTouch™ Flovair Seat
Model Nos. ITFG, ITFM
NOTE: Check all parts for shipping damage. In case of shipping damage, DO NOT use.
Contact carrier/dealer for further instruction.
To ensure the safe installation, operation and use of the Flovair seat, these
instructions MUST be followed:
ƽ WARNING
DO NOT use this equipment without first reading and understanding these
instructions. If you are unable to understand the Warnings, Cautions, and
Instructions, contact distributor before attempting to use this equipment,
otherwise, injury or damage may result.
Check all parts for shipping damage and test before use. In case of damage,
DO NOT use. Contact the distributor for further instructions.
The Flovair cushion IS NOT designed for use in the treatment of pressure
sores.
Skin condition should be checked very frequently after the installation of any
new seat.
Your therapist and physician should be consulted if you have any questions
regarding weight relief, self-examination of the skin, or individual limitations
and needs.
Make sure the hook and loop fastening straps are securely attached between
the seating surface and cushion before using.
The Flovair cushion has a weight limitation of 250 lbs for cushion widths up to
and including 20” and 350 lbs for cushion widths over 20”.
Invacare products are specifically designed and manufactured for use in
conjunction with Invacare accessories. Accessories designed by other
manufacturers have not been tested by Invacare and are not recommended
for use with Invacare products.
ƽ INSTALLATION WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching component parts are secure.
NOTE: Fluid in the pelvic pressure‐relieving insert may have a tendency to migrate
downward if the cushion is resting or stored in the vertical position. If this is the case, please
remove the outer/inner cover to inspect the insert. If migration has occured, gently knead
the insert to ensure a uniform volume of fluid exists across the surface.
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS