Invacare I.V./O2 1496 User Manual

Safety summary, Installing iv/o2 cylinder holder (figure 1), I.v./o

Advertising
background image

NOTE: Check all parts for shipping damage. If ship-
ping damage is noted, DO NOT use. Contact Dealer/
Invacare for further instructions.

SAFETY SUMMARY

The following recommendations are made for the
safe installation of the IV/O2 Cylinder Holder
Accessory Kit:

WA R N I N G

DO NOT assemble or use this equipment
without first reading and understanding
this instruction sheet. If you are unable to
understand the Warnings, Cautions or In-
structions, contact a healthcare profes-
sional, dealer or technical personnel if ap-
plicable before attempting to install this
equipment - otherwise, injury or damage
may occur.

After ANY adjustments, repair or service
and BEFORE use, make sure all attach-
ing hardware is tightened securely.

Follow the Oxygen Cylinder manufactur-
ers guidelines for proper usage of the oxy-
gen cylinder.

INSTALLING IV/O2 CYLINDER
HOLDER (FIGURE 1)

NOTE: IF rear step tube is 7/8-inch diameter tubing, in-
stall the long tube guide insert into the rear step tube be-
fore installing the IV/O2 cylinder holder.

1. Place the IV/O2 cylinder holder and slide it onto the

rear step tube of the wheelchair.

NOTE: IF rear upright tubing is 7/8-inch diameter tub-
ing, install the short tube guide insert over the rear
upright before installing and securing the IV/O2 cylin-
der holder bracket.

2. Push the bracket of the IV/O2 cylinder holder over the

rear upright of the wheelchair and secure in place with
the hex screw, spacer and locknut.

3. Secure IV/O2 cylinder holder to push handle using a

ty-wrap.

4. Loosen the short adjustment knob to move IV/O2

cylinder holder to desired height and then retighten.

5. Use the long adjustment knob on the IV/O2 cylinder

holder bracket to secure the oxygen cylinder in place.

Spacer

Rear Step

Tube

IV/O2 Cylinder Holder

Ty-wrap

Short

Adjustment

Knob

Long

Adjustment

Knob

Short

Tube

Guide

Insert

Long Tube Guide

Insert

Locknut

Rear

Upright

Push

Handle

FIGURE 1 - INSTALLING IV/O2 CYLINDER

HOLDER

Hex

Screw

Bracket

I.V./O

2

Cylinder Holder Accessory Kit

Assembly, Installation and Operating Instructions

Model Nos. 1487,1496 and T1496

Invacare Corporation

www.invacare.com

USA

Canada

One Invacare Way

5970 Chedworth Way

Invacare

®

and Yes, you can. are trademarks of Invacare

Elyria, Ohio USA

Mississauga, Ontario

Corporation.

44036-2125

L5R 3T9, Canada

© 2000 Invacare Corporation

800-333-6900

905-890-8838

Form No. 91-201 Part No. 1027931

Rev E (1) 12/00

Advertising
This manual is related to the following products: