Invacare 1036794 - Manual

SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage before us-
ing. In case of damage, DO NOT use the equipment.
Contact the Dealer/Carrier for further instructions.
SAFETY SUMMARY
The following recommendations are made for the
safe use of the Space Saver/ Conventional Arm
Socket Assemblies:
GENERAL WARNING
DO NOT install or use this equipment with-
out first reading and understanding these
instructions. If you are unable to under-
stand the Warnings, Cautions or Instruc-
tions, contact a healthcare professional,
dealer or technical personnel before at-
tempting to install this equipment - other-
wise, injury or damage may occur.
INSTALLATION WARNING
After ANY adjustments, repair or service
and BEFORE use, make sure that all at-
taching hardware is tightened securely.
PURPOSE
To replace existing half-arms or install new FIXED or AD-
JUSTABLE arms on Invacare MVP and STYLE wheel-
chairs built after 10-10-92.
The Invacare MVP or STYLE can be fitted with Space
Saver or Conventional mounting brackets with either fixed
oradjustable arms. These arms can be used on all chairs
14 through 18 inches.
FRONT ARMREST SOCKET
REPLACEMENT/H-BLOCK
INSTALLATION (FIGURE 1)
1. Remove the locknut and screw securing the H-block
to the right and left front frames (FIGURE 1).
2. Remove the H-blocks.
NOTE: It may be necessary to reposition the wheel lock
assembly before/after installing the new front armrest sock-
ets/H-Blocks.
3. Position the NEW armrest socket/H-Block onto the
right and left front frames by performing one (1) of the
following:
NOTE: Armrest sockets/H-Block MUST be positioned
in the 1st or 2nd mounting hole on the right and left front
frames depending on the type of wheelchair.
A. MVP/STYLE 14 through 16 inches deep - Align
the mounting hole in the H-block with the first
mounting hole on front of chair.
B. ALL type wheelchairs 17 and 18-inch deep - Align
the mounting hole on the H-block with the second
mounting hole on front of chair.
FIGURE 1 - FRONT ARMREST SOCKET
REPLACEMANT/H-BLOCK INSTALLATION
1
Front Frames
Mounting
Holes
Armrest Socket/
H-Blocks
Mounting
Holes
Space Saver / Conventional Arm Socket Assemblies
Assembly, Installation and Operating Instructions
Kit Numbers 1036793, 1036794, 1094952, 1094953