Intel NSI2U - Manual (Page 8)

Base System Definitions
4 Revision 1.3 4
2. Base System Definitions
The following table lists the base system configurations tested for a given validation test run.
Each specific product/system software combination tested is assigned a Base System Identifier
Number. These numbers are used in the lists of supported adapters and peripherals referenced
in the following sections.
The adapters and peripherals specified in this document may or may not have been tested on
all available board/riser combinations that make up the TIGI2U and the NSI2U product family.
However, Intel will provide support for the adapters and peripherals listed when used within this
family of products
This table is updated when a new test run is performed and a new product/system software
combination was used.
 Intel will only provide support for adapters and peripherals under the specified
operating systems versions with which they were tested.
Base System
Configuration
Identifier #
Product Family
BIOS
Revision
mBMC/BMC
Firmware
Revision
HSC Firmware Revision
1
Intel ® Server Board
SE7520JR2 in
Intel ® Chassis
SR1400/SR2400
Production
Release
P07.x
mBMC FW2.40
IMM BMC FW 32
SCS1 1.06
SATA 1.08
2
Intel ® Server Board
SE7520JR2 in
Intel ® Chassis
SR1400/SR2400
Production
Release
P08.x
mBMC FW2.40
IMM BMC FW 46
SCS1 1.06
SATA 1.08
3
Intel ® Carrier
Grade Server
TIGI2U
Production
Release
P08.10
mBMC FW2.40
IMM BMC FW 48
SCSI 1.01
4
Intel ® Carrier
Grade Server
TIGI2U
Production
Release
P10
mBMC FW2.40
IMM BMC FW 48
SCSI 1.01