JVC HR-J245EA - Manual (Page 17)

EN
17
4
¶
1
4 ¢
7
3
8
¡
1 2 3
4 5 6
7 / 8
0
9
2
1
3
NOTES:
● You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
੬
pg. 21, "Check And Cancel Programmes").
● In case of a power failure after programming, the recorder’s
memory backup keeps your selections (if the lithium battery
is not exhausted).
ATTENTION
Regarding Guide Program Number Set
"ERROR=GUIDE PROG" appears after performing step 3 on
the previous page if the Guide Program number for the
G
-CODE number you entered has not been set.
● If the recorder is in the stop or rewind or fast-forward
mode, the following screen will appear with "– –" under
"TV PROG" blinking.
• Press the NUMBER keys or PUSH JOG %fi to input the
channel position number you recorder receives that
station on, then press OK.
• Press MENU, then try again from step 1.
● If the recorder is in a mode other than the above mentioned
modes, press MENU first and input the correct Guide
Program number for that G
-CODE number (
੬
pg. 14,
"G -CODE Setup"), then try again from step 1.
(Ex.) To timer-record a SBS
programme with G
-CODE
* If your recorder receives
SBS on the channel position
2, press OK after entering
"2".
G-CODE SET-UP
GUIDE PROG TV PROG
2 – –
[0-9] OR [ 5/∞] : SELECT =
[MENU] : EXIT
NUMBER
OK
MENU
PUSH JOG