Jet Tools OES-80CS - Manual (Page 16)

16
Contour Sanding
Referring to Figure 19:
Contour sanding is done from the extension table
mounted on the motor where the sanding belt
wraps around the drive drum (D). To set up the
sander for contour sanding:
1. Loosen the two lock knobs (C) that secure the
drum guard & dust port (E).
2. Swing the end guard (E) back, bringing the
drive drum (D) into view.
3. Tighten the lock knobs (C).
4. Mount the extension table (A) to the sander by
inserting the post (B) into the bracket (F).
5. Set the table to the desired height, then secure
into position by tightening the lock knob (G).
Important: When the extension table (B) is not in
use, the drum guard & dust port (E) should always
be in the closed position so the drive drum (D) is
not in view.
Figure 19