John Lewis JLDWS1208 - Manual (Page 28)

Remove the machine’s worktop by
unscrewing the two rear retaining screws (1),
pull the worktop from the back of the machine
(2) and slide out the front slots, lifting the
worktop (3). Insert the machine after adjusting the levelling
with the adjustable feet. When inserting the
machine, ensure that the water inlet and drain
hoses are not kinked or squashed.
During all operations that involve accessibility
to internal components the dishwasher has to
be unplugged.
Be sure that once the appliance has been
installed, it is easily accessible for the service
engineer in the event that a repair is required.
If the dishwasher is later used as a free-
standing appliance, the original worktop must
be re-mounted.
The plinth on free-standing appliances is not
adjustable.
Levelling
Good levelling is essential for correct closure
and sealing of the door. When the appliance
is correctly levelled, the door will not catch on
either side of the cabinet. If the door does not
close correctly, loosen or tighten the
adjustable feet until the machine is perfectly
level.
Water connections
Water inlet connection
This appliance must be connected to a cold
water supply.
For making the connection itself, the coupling
nut fitted to the machine’s inlet hose is
designed to screw onto a 3/4" gas thread
spout or to a purpose made quick-coupling
tap such as the Press-block.
The water pressure must be within the limits
given in the "Technical data". Your local
Water Authority will advise you on the
average mains pressure in your area.
28