Juniper Networks ERX Hardware 8 - Manual (Page 156)

ERX 8.0.x Hardware Guide
Juniper Networks provides recycling support for our equipment worldwide
to comply with the WEEE Directive. For recycling information, go to
http://www.juniper.net/environmental , and indicate the type of Juniper Networks
equipment that you wish to dispose of and the country where it is currently
located, or contact your Juniper Networks account representative.
Products returned through our reclamation process are recycled, recovered, or
disposed of in a responsible manner. Our packaging is designed to be recycled and
should be handled in accordance with your local recycling policies.
Hardware Compliance
The router meets the following hardware compliance requirements.
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This equipment is designed for use with properly shielded and terminated cables.
Refer to the installation sections of this manual before operation.
Reference: CFR 47, Part 15J, Sect 15.105 April 18, 1989
Caution: Changes or Modifications to this equipment not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
138 Hardware Compliance