Assembly, Securing machine to stand, Wooden table – Jet Tools 719T WMH User Manual

Page 8: Operating handle

Advertising
background image

8

Assembly

Do not connect the machine

to power source until completely
assembled. Read and understand the entire
manual.

Securing Machine to Stand

The mortiser should be secured to the stand
with four M8 x 45 hex cap screws and M8 lock
washers (provided) using the holes in the base.
Make sure there is enough room on each side
of the mortiser for the size stock you plan to
use.

Wooden Table

Referring to Figure 1:

1. Place the wooden table (A) in position on

the slide (B).

2. Secure with two Phillips head screws

provided (C).

Operating Handle

Referring to Figure 2:

1. Fasten

operating handle (A) to the hub (B)

and tighten with a 14mm open-end wrench.

2. Raise mortising machine head to the up

position by moving the operating handle
(A) up.

Note: The handle assembly is spring-loaded
and can be repositioned by pulling out the
hub (B) and repositioning it on the pinion
shaft (C).











Figure 1

Figure 2

Advertising