JVC KD-AV7000 User Manual
Page 347
3
(PARKING BRAKE)
1
2
3
5
6
4
7
2
1
(ILLUMINATION)
3
4
2
1
2
1
6A
Fuse block
To a live terminal in the fuse block connecting to the car battery (bypassing the
ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To metallic body or chassis of the car
Ignition switch
*
1
Not supplied with this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
Orange with white stripe
Red
Yellow*
2
Black
Yellow
*
2
Blue with white stripe
Fuse block
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To metallic body or chassis of the car
Black
Gray with black stripe
White
White with black stripe
Green with black stripe
Gray
Green
Purple with black stripe
Purple
To the remote lead of other equipment—200 mA max.
Left speaker (rear)
Right speaker (front)
Left speaker (front)
Right speaker (rear)
Ignition switch
Light green
To automatic antenna if any—250 mA max.
Blue
Main unit
Hideaway unit
*
1
*
1
*
1
*
1
To parking brake of the car
15 A fuse
PRECAUTIONS on power supply and
speaker connections:
• DO NOT connect the speaker leads of the
power cord to the car battery; otherwise, the
units will be seriously damaged.
• BEFORE connecting the speaker leads of the power
cord to the speakers, check the speaker wiring in
your car.
L
R
+
-
+
-
+
-
+
-
L
R
+
-
+
-
+
-
+
-
L
R
+
-
+
-
+
-
+
-
Where-to-connect depends on your dimmer usage.
For details, see page 46 of the Instructions.
PARKING
BRAKE
h
Connecting the parking brake wire
Connect the parking brake wire to the parking brake system built in the car.
To metallic body or chassis
of the car
Parking brake switch (inside the car)
Parking brake wire (light green)
Parking brake
Contact the metallic part of the crimp
to the wires inside.
Attach the parking brake wire (light green) to this point.
Wire connecting the battery and the parking brake switch.
Pinch the crimp firmly.
How to connect the crimp connector
m
n
Tapping screws (not supplied)
Floor
ı
Installing the hideaway unit (under the front seat)
• Be sure to use the tapping screws (not supplied) of appropriate length so that they will not
damage any parts of the car.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the wiring harness to the units.
3
Connect the main unit and the hideaway unit using AV bus cable (supplied).
Ç
Electrical connections
Before connecting...
• Make sure that the antenna cord from the car is connected to the hideaway unit (see page 2). If the
antenna cord is not long enough, use the extension antenna cord (supplied).
• Check the wiring in the car carefully. Incorrect connection may cause serious damage to the units.
The leads of the power cord and those of the connector from the car body may be different in color.
Brown
To cellular phone system
InstallKD-AV7008_2[A]5.p65
04.10.5, 3:49 PM
3