Et up the, Yper, Erminal with – Jameco Electronics 527822 User Manual
Page 26: To serial port, Set up the hyperterminal with usb to serial port
Set up the HyperTerminal with USB to serial port
Follow the steps below to configure your HyperTerminal with USB to serial COM
port setting:
1. Make sure that HyperTerminal is installed in your system. If not, please click
Start, Settings, Control Panel, double click Add/Remove Programs, choose
Windows Setup page, Communications, click Details button, enable
HyperTerminal to install the program to your Windows system.
2. Please click on Start, Settings, Control Panel, double click System, and click on
Device Manager. Check which COM port is located by USB to serial port.
Figure 8
3. If you have setup HyperTerminal before, please run Start, Programs,
Accessories, Communications, HyperTerminal, HyperTrm.exe. Click File,
Properties. The Properties dialog page will appear on your screen. If it is your
first time to setup HyperTerminal, you will see this page during the setup
procedure.
USB 2.0 DOCK User’s Manual
- 25 -