John Lewis JLFZW 1806 - Manual (Page 7)

7
Unpacking
Remove all packaging before positioning the appliance.
Remove the transport supports placed along the door
sides.
Some models are fitted with a silencing pad under the
freezer. Do not remove this pad.
Installing the freezer
When two appliances are placed beside each other, the
spacers enclosed in the plastic wrapping should be glued
between the appliances. As shown in the illustration.
Make sure that the power plug is not squashed
or damaged by back of the product.
D
A damaged power plug may overheat and cause a fire.
Do not place heavy articles or the product itself
on the power cord.
D
there is a risk of a short circuit and fire.
If the power plug socket is loose, do not insert
the power plug.
D
there is a risk of electric shock or fire.
To obtain the best performance from the freezer,
ensure :
D
the freezer is placed in a dry, cool place and is not
exposed to direct sunlight.
D the freezer is not placed close to a source of heat, e.g. a
cooker or dishwasher.
D the freezer is level. The freezer should not leanagainst
any wall. If necessary adjust the feet using the
adjustment spanner supplied.
D there is good air circulation around the freezer and that
the air channels below and behind the freezer are not
blocked. The ventilation space between the freezer and
a cupboard above must be at least 40mm.
The ventilation space can either be
a) directly above the freezer, or
b) If a cupboard is placed immediately above the freezer
there should be a ventilation gap behind the cupboard of
50mm deep and at least a 40mm gap between the top of the
cupboard and the ceiling.
If the freezer is placed in a corner and the side with the
hinges facing the wall, the distance between the wall and
the freezer must be at least 15 mm to allow the door to
open enough so that the baskets can be removed.
The power plug must be accessible after installation of
the freezer.
50mm
a) b)