Jet Tools JWBS-14OCS - Manual (Page 12)

12
Assembly of JWBS-14CS
Tools Required for Assembly
Metric combination wrench set and
adjustable wrench
#1 and #2 cross point screwdrivers
Exposed metal surfaces, such as the table, have
been given a protective coating. This should be
cleaned with a soft cloth and solvent, such as
kerosene. Do not use an abrasive pad, and do
not get solvents on plastic parts.
1. Remove pulley cover from inside of stand.
2. Place cabinet stand upright on a level
surface. If desired, the stand can be further
stabilized by securing it to the floor with lag
screws through the inside corner holes. If
using a mobile base, lock the casters before
assembling or operating the band saw.
Saw body is heavy! Use
caution when lifting and stabilize until firmly
attached to the stand! Failure to comply may
cause serious injury!
3. With the aid of a second person, lift the saw
body out of the shipping container and place
onto stand top. Be sure front of saw (with
JET logo) faces stand front (JET logo).
4. Line up holes in saw body with holes in top
of stand. Fasten saw body to the stand with
four M8 x 40 hex cap screws, eight M8
washers, four M8 lock washers, and four M8
hex nuts (as shown in item A, page 8).
5. Push motor cord and strain relief plate
through the opening in the side of the stand
(Fig. 12). Fasten the strain relief plate to the
stand with two M5 x 12 pan head machine
screws (shown in item B, page 8).
6. Check the alignment of the pulleys by
placing a straight edge against the flat sides
of the motor and wheel pulleys (Figure 13).
If the pulleys lie in a straight plane (Figure
14) they are aligned. If they do not lie in a
straight plane, loosen the set screw on one
of the pulleys and shift the pulley in or out
until both pulleys lie in a straight plane.
Tighten set screw.
Figure 12
Figure 13
Figure 14