Jabra HALO2 - Manual (Page 11)

10
en
g
li
sh
Jabra HaLO2
I cannot hear music in the headset
- ensure that the headset is connected to your bluetooth
enabled device .
- you may have been out-of-range (10 meters) to your bluetooth
enabled device or the headset might have experienced an esd
(electrostatic discharge) incidence . Press the multi function
button to re-establish the bluetooth audio link .
- Increase the volume on your device .
- make sure that the Jabra HaLO2 is charged .
The music I hear sounds very poor
make sure the other device supports bluetooth 1 .1 or higher
including the advanced audio distribution Profile (a2dP) for
music streaming .
If the above procedure did not help then it is possible that your
phone is using the stereo audio connection in a different way . you
can enable this mode on Jabra HaLO2 by performing pairing in
the following way:
- remove the bluetooth connection to Jabra HaLO2 on your
phone
- make sure the headset is on (un-folded)
- Press and hold the answer / end button for more than 5 seconds
until the both display icons are solid blue and solid Orange
- Go through the regular steps in pairing the headset to
a bluetooth device .
be aware that standby time of the Jabra HaLO2 can be lower
when using this pairing .
takInG Care of your headset
- always store the Jabra HaLO2 with the power off and safely
protected
- avoid storage at extreme temperatures (above 45°C/113°f –
including direct sunlight – or below -10°C/14°f) . This can shorten
battery life and may affect operation . High temperatures may
also degrade performance .
- do not expose the Jabra HaLO2 to rain or other liquids .