Jet Tools HBS-1321W WMH - Manual (Page 11)

11
Guide Roller Adjustment
The bearings come pre-adjusted from the
factory. If adjustment is needed follow the below
steps:
1. Disconnect machine from the power
source.
2. Loosen two hex socket cap screws (A, Fig. 9).
3. Move guide seat (B, Fig. 9) up or down until
an approximate clearance of .003" between
blade and bearing is obtained, (C, Fig. 9).
4. Tighten two hex socket cap screws (A, Fig. 9).
5. Adjust the eccentric bearings (A, Fig. 10) by
loosening hex socket cap screw (B, Fig. 10)
about one full turn.
6. With a 19mm wrench turn hex nut (C, Fig.
10) until the ball bearings are approximately
.003”. Note: Do not pinch the blade.
7. Tighten the hex socket cap screw (B, Fig.
10) while holding the hex nut (C, Fig. 10) in
place.
8. Repeat for other blade guide assembly.
9. Connect machine to power source.
Blade Guide Adjustment
The blade guides come pre-adjusted from the
factory. If adjustment is needed follow the below
steps:
1. Disconnect machine from the power
source.
2. Adjust spring loaded blade guide (A, Fig. 11)
by loosening or tightening the guide
adjustment screw (B, Fig. 11).
3. The blade guide should place a light
pressure on the blade.
4. Connect machine to the power source.