Jeep COMMANDER 2010 - Manual (Page 45)

BRAKE/TRANSMISSION
INTERLOCK MANUAL
OVERRIDE
• The manual override may be used in
the event that the shift lever should fail
to move from PARK with the Key Fob in
the ON position and the brake pedal
pressed.
• To operate the shift lock manual
override, perform the following steps:
• Turn the Key Fob to the ON position
but do not start the engine.
• Firmly set the parking brake.
• Using a flat-bladed screwdriver,
carefully remove the shift lock
manual override cover which is
located on the PRNDL bezel.
• Press and maintain firm pressure
on the brake pedal.
• Using the screwdriver, reach into the
manual override opening. Press and
hold the shift lock lever down.
• Press the Shifter Release button and
shift into NEUTRAL.
• The vehicle may then be started in
NEUTRAL.
• Have your vehicle inspected by your
local authorized dealer if the shift lock
manual override has been used.
43
UTILITY