Specifications – JBL MPA275 User Manual

Page 17

Advertising
background image

16

SMPTE-IM, less than 0.05 %

20 Hz to 20 kHz, ±0.1 dB
8 Hz to 100 kHz, +0/-3 dB

Greater than 200

3 dB at 4 ohms (2 dB for MPA275)

100 dB below rated output (20 Hz to 20 kHz)

1 Vrms for rated power (8 ohms)

MPA1100: 80 (38 dB)
MPA750: 63 (36 dB)
MPA600: 56 (35 dB)
MPA400: 45 (33 dB)
MPA275: 35.5 (31 dB)

10 kilohms unbalanced, 20 kilohms balanced

Front: AC switch, Ch 1 & Ch 2 Gain (2 dB detents). Rear: One toggle switch for
paralleling inputs and for bridged output configuration

POWER: Green

LED

SIGNAL PRESENT: Green LED
LEVEL -20: Green LED
LEVEL -10: Yellow LED
CLIP: Red LED
PROTECT: Red LED (flashes for over-temp)

Input: Barrier strip and XLR
Speakers: 5-way binding posts, Speakon connectors, st. Speakon**

Continuously variable speed fan, rear-to-front air flow

Full short circuit†, open circuit, ultrasonic, and RF protection, thermal limit-
ing/muting; stable into reactive or mismatched loads

On/off muting, clip limiting, DC-fault load grounding relay with internal fault
fuses

Complementary linear, high-efficiency outputs: 3-step on MPA1100; 2-step on
MPA750, MPA600 & MPA400; 1 step on MPA275

100, 120, 220–240 Vac, 50–60 Hz

See Charts on pages 9 and 10.

48.3 cm (19") rack mounting,
45.5 cm (17.9") deep (rear support ears),
MPA1100 & MPA750 are 13.3 cm (5.25") high (3 spaces);
MPA600, MPA400 & MPA275 are 8.9 cm (3.5") high (2 spaces)

MPA1100: 29 kg (64 lbs) net, 31.8 kg (70 lbs) shipping
MPA750: 24.9 kg (55 lbs) net, 26.8 kg (59 lbs) shipping
MPA600: 20 kg (44 lbs) net, 22.2 kg (49 lbs) shipping
MPA400: 19.1 kg (42 lbs) net, 21.2 kg (47 lbs) shipping
MPA275: 18.1 kg (40 lbs) net, 20.4 kg (45 lbs) shipping

Specifications

DISTORTION

FREQUENCY RESPONSE

DAMPING FACTOR

DYNAMIC HEADROOM

NOISE

SENSITIVITY

VOLTAGE GAIN

INPUT IMPEDANCE

CONTROLS

INDICATORS

(each channel)

CONNECTORS

(each chan., except one stereo Speakon)

COOLING

AMPLIFIER PROTECTION

LOAD PROTECTION

OUTPUT CIRCUIT TYPE

POWER REQUIREMENTS

POWER CONSUMPTION

DIMENSIONS

WEIGHT

General Specifications

Continued

** For mating cable, use Neutrik NL4FC connector.
†Output Averaging™ short circuit protection (US Patent 4,321,554).

Advertising
This manual is related to the following products: