JobSite Systems A45-X2 - Manual (Page 6)

4
PACKAGE CONTENTS
■
A45-X2 x 1
■
Removable AC power cord x 1
PREPARING FOR
INSTALLATION
Placement
Place the A45-X2 on a flat level surface like
a table or shelf. It should be placed upright
so that its weight rests on the four attached
feet. Placing the weight of the amplifier on
the rear or front panel may result in damage
to the amplifier's connectors and controls.
The A45-X2, like any hi-fi component, will
last much longer if it is given adequate
ventilation for proper cooling. When
installing the A45-X2 in a cabinet, be sure
that the rear of the cabinet is open to fresh
air to provide proper cooling. See Figure 2.
If the cabinet’s design will not
accommodate an open rear, install two
small “boxer fans” to provide continuous
airflow into and out of the cabinet. See
Figure 3. Place the A45-X2 so that there is
at least 5" of free air space above the
chassis. If the amplifier is located on a
carpeted surface, place a board under the
amplifier's feet. Do not block the ventilation
holes on the top and bottom of the A45-X2.
TURN-ON MODES
The Turn-On Mode selector switch gives
you three options for turning the A45-X2 on
and off.
Slide the switch with your fingernail
or a 1/8" slotted screwdriver blade.
Make sure that there is a minimum of
5" of free air space above the amplifier
for proper ventilation.
Allow a minimum of 2" of depth behind
unit to accommodate cables and
connectors.
Figure 2
If the cabinet rear is not open to fresh
air, install two small “boxer fans” to
provide continuous air flow into and
out of the cabinet.
Figure 3