JVC KD-S52 - Manual

GET0322-002A
[J]
0805DTSMDTJEIN
EN, SP
J
Handles F
Washer (ø5) G
Lock nut (M5) H
Mounting bolt—
M5 x 20 mm (M5 x 13/16") I
Rubber cushion
A / B
Hard case/Control panel C
Sleeve D
Trim plate E
Power cord
Do the required electrical connections.
Bend the appropriate tabs
to hold the sleeve firmly in
place.
Parts list for installation and connection
INSTALLATION (IN-DASH MOUNTING)
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
K
Remote controller L
Battery
Removing the unit
Before removing the unit, release the rear section.
Heat sink
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
ELECTRICAL CONNECTIONS
Make sure to disconnect the battery’s negative terminal.
• Be sure to ground this unit to the car’s chassis again after installation.
Note:
It is recommended to connect to the speakers with maximum power of more than 50 W (both at
the rear and at the front, with an impedance of 4
Ω to 8 Ω). If the maximum power is less than
50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 19 of
the INSTRUCTIONS).
ENGLISH
You need the installation kits which corresponds to your car.
• Mark all the check boxes (
) to make sure you have follow the instructions and the listed
parts.
12 V DC, NEGATIVE ground
1
When using the optional stay
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the unit at an
angle of less than
30˚.
When installing the unit without
using the sleeve
In a Toyota for example, first remove the car
radio and install the unit in its place.
Bracket
Flat type screws—
M5 x 8 mm (M5 x 3/8")
Flat type screws—
M5 x 8 mm (M5 x 3/8")
High
Check the battery system in your car.
Bracket
KD-S52
Installation/Connection Manual
Manual de instalación/conexión
Instal_EN_KD-S52[J]f.indd 2 Instal_EN_KD-S52[J]f.indd 2 7/25/05 10:15:44 AM 7/25/05 10:15:44 AM