SysKonnect SK-98xx V2.0 - Manual (Page 28)

28 4 Installation of the Driver Software
Once you have entered all information, the message “
Are these settings OK (y/
n)?
” is displayed.
12. If all settings are OK, type
y
.
13. Press <Enter>.
The message “
Do you have more SysKonnect Gigabit Ethernet interface
adapters installed (y/n)?
” is displayed.
14. If yes, type
y
.
If no, type
n.
15. Press <Enter>.
If you have typed
y
in step 14, repeat steps 11 to 13.
If you have typed
n
, continue with step 16.
16. When the message “
Do you want to continue with the installation of
<SKGEsol> [y, n,?]
” is displayed, type
y
.
The driver package is installed.
”Admintool” will prompt you to reboot after successful installation, but this may be
ignored.
For more information, refer to the corresponding readme file.
HP-UX
The driver supports the SysKonnect SK-98xx family on HP-UX 11 systems. The driver pack-
age for HP-UX can be either installed using the administration/installation GUI or a shell com-
mand.
To perform the following tasks, you need “root” access.
Drivers downloaded from our web site are available in a packed format (.tar.gz files). The
downloaded package has to be unpacked before installation.
Unpack the driver To unpack the downloaded driver package, proceed as follows:
1. Go to the directory where the packed driver package “<package file>.tar.gz” is located.
2. Unpack the file with the following command:
gunzip <package file>.tar.gz
The unpacked file has the format “<package file>.tar”.
3. Untar this file with the following command:
tar -xf <package file>.tar
The result is the file “<package file>.depot” and the readme file in “.txt” and “.html” format.
The driver package is now ready to be installed.
Use the GUI You can either use “sam” or “swinstall”. “sam” also calls “swinstall”, i.e. the installation is iden-
tical (from step 3 onwards). In the following, the installation with “sam” is described.
To install the driver package, proceed as follows:
1. After you have installed the adapter in your computer, boot the HP-UX system (for
details, see chapter 2 "Installation of the Network Adapter").
2. Start “sam”.
3. In “sam”, select S OFTWARE M ANAGEMENT > I NSTALL SOFTWARE TO LOCAL HOST .
4. Specify the S OURCE DEPOT TYPE by selecting L OCAL D IRECTORY .
5. Specify the S OURCE HOST NAME by entering the
<host name>
, e.g.
hpdev.
6. Specify the S OURCE DEPOT PATH by typing the full path to the package file and the name
of the package file,
e.g.
usr/tmp/skge_HPUX11.00_64b_v6.00.depot.
7. Specify the S OFTWARE FILTERS by entering
None.
8. Confirm with O K .