Smooth Fitness 9.65LC - Manual (Page 35)

www.smoothfitness.com 35
TROUBLESHOOTING
TROUBLE SHOOTING GUIDE:
SYMPTOM CAUSE SOLUTION
Show E0 Safety key not in place
Place the safety key into the operation
position
Show E1 Speed signal error
Please check Speed sensor and 10-pin
cable or contact your retailer
Show E2 Motor or motor drive system error
Check the 10-pin cable or contact you
retailer
Show E3 Over speed error
Adjust the speed sensor or contact your
retailer
TROUBLE SHOOTING YOUR TREADMILL:
If you experience a problem, please refer to the trouble shooting guide listed below:
PROBLEM: The console does not light up.
SOLUTION: Verify that the power cord is plugged in properly to the outlet, and the
treadmill power switch is turned on.
PROBLEM: The treadmill circuit breaker trips during a workout.
SOLUTION: Verify that the treadmill is plugged into a dedicated 15 amp circuit with the correct outlet.
*Note: Do not use an extension cord.
PROBLEM: The treadmill shuts off when elevating.
SOLUTION: Verify that there is enough slack in the power cord to reach to the wall
outlet during elevation.
PROBLEM: The running belt does not stay centred during a workout.
SOLUTION: Verify that the treadmill is on a level surface. Verify that the belt is
properly tightened. (Refer to Belt Adjustment)
PROBLEM: The treadmill makes a clicking noise towards the front of the machine
while walking or running on it.
SOLUTION: Verify that the treadmill is on a level surface.