SWR Sound Mini-Mo' Preamp With Mo' Control 2 Master Footswitch Controller - Manual (Page 27)

front panel and heads for the Effects Send jacks just after the Chorus section. Then the signal returns
just before the Master section and is blended in to your taste (using the External Effects Blend
controls). The Stereo Master Volume controls will NOT affect the level of your Left and Right Effect
Sends. However, the Stereo Master Volume controls may be used to recover losses in gain caused by
some effects units.
If your effects unit is overloading and it does not provide for compensating incoming signals––such as
an input volume, or switches marked +4 dB or -20 dB––you may want to turn down the Preamp
Volume control to avoid the overloading. If your effects unit has input level adjustments, they should be
set for either 0 dB or +4 dB.
And, of course, always use high quality shielded patch cables for all connections between the amplifier
and your effects units. Also, it is recommended that they be as short as possible.
A QUICK REMINDER: A QUICK REMINDER: No sound from your external effects device will be heard if the External Effects
Blend controls are in the full counter-clockwise ("dry") position! This is normal.
WHAT HAPPENS WHEN DUAL MODE IS ENGAGED?
Good question. What kind of signal is present at the Left and Right Effects Send jacks when Dual Mode
is engaged?
The Left Effects Send jack will now see the "clean/left" channel, which is the entire Preamp section and
its EQ, but NO ONBOARD Mini-Mo’ PREAMP EFFECTS. In short, the "Dual Mode" switch changes the
function of this jack.
The Right Effects Send jack will see the "wet/right" channel, which essentially means that it will not
change––it always sees everything, including the Preamp EQ at all times and Mini-Mo' Preamp effects
when engaged.
INTERNAL EFFECTS (EFX) BYPASS JACK
This is the input jack to use if you wish to connect any momentary (normally open) footswitch so as to
operate the Internal Effects Bypass control separately from the Mo' Control 2 Master Footswitch. The
function can be used to bypass any onboard Mini-Mo' Preamp effect currently engaged. Please refer to
the previously mentioned Internal Effects Bypass section of the manual for more details.
FILTER SWEEP PEDAL JACK
This is the input jack for controlling the Bassynth Filter control by means of an "Expression Pedal."
Please refer to the previously mentioned "Using The Bassynth - Filter Sweep Pedal" section of the
manual for more details.
MO' CONTROL 2 FOOTSWITCH INPUT JACK (MARKED "FOOT SWITCH") & MIDI OUT JACK
This standard HD15 jack connects the Mo' Control 2 Master Footswitch to the Mini-Mo' Preamp. This
footswitch allows the user to perform hands-free control of the various effects, as well as store groups
of effects in four preset banks. Please refer to the section marked Mo' Control 2 Master Footswitch later
on in this manual.
MIDI OUT JACK
This jack, in conjunction with the Mo' Control 2 Master Footswitch, allows you to send simple MIDI
commands to a MIDI-capable external effects device. Please refer to the section marked "How Mo'
Control 2 Can Act As A MIDI Controller" later on in this manual.
MINI-MO’ OWNER’S MANUAL •24