SVAT Electronics GX5201 - Manual (Page 6)

GX5201 4
SVAT ELECTRONICS
Now You Can See
Accordingly the DIP switch located on the back of the monitor should be adjusted to
reflect the channel in use.
Night Vision
The camera includes 8 built-in IR LEDs, which allow viewing of up to 5 feet in the dark.
To turn on the IR LEDs, use the small switch on the side of the camera. Switching it to
the moon icon activates night vision, and switching it to the sun icon turns it off.
Sound-Activated Alarm Feature
When the camera detects sound, an audio alert sounds on the monitor. To adjust the
sound trigger sensitivity level, adjust the dial labeled trigger located beside the camera's
antenna.
Operating Modes
The system can be set to operate in one of 3 modes: SCAN, AUTO or MANUAL. The
desired operating mode can be selected using the buttons on the front panel of the
monitor.
Scan
Pressing the SCAN button places the system in scan mode. The monitor's screen will go
blank (standby mode) while the system continuously scans active cameras. If a camera
detects sound above the preset sound trigger level, the monitor will display the camera's
picture and the beeper will sound. Four minutes after the last detection, the screen
returns to standby mode and the LCD monitor resumes scanning. Press the MANUAL or
AUTO button to cancel this mode.
Auto
Pressing the AUTO button places the system into auto mode. In this mode, the system
automatically rotates through all active cameras. When a camera detects sound above