Standard Horizon CPV350 - Manual (Page 106)

Page 106 CPV350
19.6.1 Transmitting a Group Call
Using the Group calling directory
1. Press [CALL]. The “DSC Operation” menu Tabs will appear at the bottom edge of the
display.
2. Press [GROUP] to show “DIRECTORY” popup window on
the display.
3. Move the ShuttlePoint knob to the up or down or turn the
Channel knob to select the “Group” you want to contact.
4. Press [ENT], then turn the Channel knob to select the
operating channel you want to communicate on and press
[ENT].
5. Press [ENT] again to transmit the Group Call signal.
6. After the GROUP CALL is transmitted, all the radios in the group will
switch to the designated channel.
7. Listen to the channel to make sure it is not busy, then key the
microphone and call the other vessels you desire to communicate
with.
Manual Calling a Group MMSI number
You may enter a Group MMSI number manually to contact without Setting up the Group call
number.
1. Press [CALL]. The “DSC Operation” menu Tabs will appear at the bottom edge of the
display.
2. Press [GROUP] to show “DIRECTORY” popup window on the display.
3. Move the ShuttlePoint knob to the up or down or turn the Channel knob
to select “MANUAL,” then press [ENT] to show the “MMSI INPUT” window
on the display.
4. Move the ShuttlePoint knob to up or down to scroll through numbers, 0-
9 to enter the desired number and move the ShuttlePoint knob to the right
to move one space to the right (first digit permanently set to “0”). Repeat this procedure
until all nine space of the MMSI number are entered.
5. If a mistake was made entering in the MMSI number move the ShuttlePoint knob to the
left until the wrong number is selected, then move the ShuttlePoint knob to up or down
to correct the entry.
6. When finished entering the MMSI number, press the [ENT] key.
7. Turn the Channel knob to select the operating channel you want to
communicate on and press [ENT].
8. Press [ENT] again to transmit the Group Call signal.
9. After the GROUP CALL is transmitted, all the radios in the group will
switch to the designated channel.
10. Listen to the channel to make sure it is not busy, then key the
microphone and call the other vessels you desire to communicate
with.