Kompernass KH 2391 - Manual (Page 5)

7 GB/IE
et Plug-in for rear left loudspeaker (-)
eu Flat blade fuse socket
f l Flat blade fuse 10 A
fm ISO plug jack to the 12 V DC power connection
(including connection of an automatic aerial)
fn Plug-in for 12 V DC constant current
fo Plug-in for electric aerial
fp Plug-in for 12 V DC ignition current
fq Plug-in for minus / earth connection in the vehicle
fr Attachment screw (including M nut and washer)
fs OUT / REAR cinch R plug jack (loudspeaker
connection [red / rear right])
ft LINE IN R cinch plug jack (red / right)
fu LINE IN L cinch plug jack (white / left)
gl OUT / REAR cinch L plug jack (loudspeaker
connection [white / rear left])
gm Aerial socket
gn OUT / FRONT cinch plug jack (loudspeaker
connection [white / front left])
go OUT / FRONT cinch plug jack (loudspeaker
connection [red / front right])
Top of the Car Radio (see Fig. E)
gp Transport safety screw 2 x
Front of the Remote Control (see Fig. F)
gq
POWER
“POWER” button
gr
ENTER SEL
“ENTER / SEL” button
gs TUNE/
SEEK
VOL
VOL
9 :
“TUNE / SEEK” multifunction button:
gt
VOL “VOL+” button (upper)
gu
9
Skip button (back)
hl
:
Skip button (forwards)
hm VOL “VOL” button (lower)
hn
MODE
“MODE” button
ho
MP3 AS/PS
“MP3 / AS / PS” button
hp
-10 5
“-10 / ” button
hq
+10 6
“+10 / 6” button
hr
DISP
“DISP” button
hr
BAND
“BAND” button
ht
RDM 4
“RDM / 4” button
hu
RPT 3
“RPT / 3” button
il
INT 2
“INT / 2” button
im
PAU 1
“PAU / 1” button
Rear of the Remote Control (see Fig. G)
in Battery compartment
io Battery holder
ip Unlock button
Installation Accessories (see Fig. E)
iq DIN assembly bracket
ir Installation key
L  Scope of Supply
1 x Car radio (including control panel)
1 x IR remote control (including 1 x lithium battery
of type CR202, 3 V DC)
1 x Plastic box (for control panel)
1 x DIN assembly bracket
2 x Installation key
1 x Anchoring plate (including attachment material)
1 x Operation manual
L
Technical Data
Car Radio
Rated voltage: 12 V DC (minus pole negative,
connected to the body within the vehicle)
Power consumption: max. 10 A
Power output: max. 4 x 20 W active power factor
Distortion: - 40 dB (1%)
Amplifier (TDA 7386)
4-band preset EQ
Electronic master level for: bass and treble, loudness,
fade control, balance
Preamplifier Input (LINE IN)
Power output: 77 m V = 0 dB
Impedance: 47 k Ohm
Preamplifier Output (LINE OUT)
Power output: max.  V
Impedance: 10 k Ohm
Tone control
Bass frequency: 100 Hz ± 10 dB
Treble frequency: 10 kHz ± 10 dB
Introduction
KH2391_Content_UK.indd 7 05.09.2006 14:49:10 Uhr