Lenoxx Electronics PH-3235 - Manual (Page 12)

IB-PH3235(MS)-WM-E-122203
3. Snap WALL MOUNT ADAPTOR into bottom of phone as shown on adaptor (“UP”
pointing to top of phone).
4. The longer wire about 7" plugs into the rear of phone, leave the other end out showing
about 3" of wire. Plug the 3" wire into wall jack.
5. Put phone over wall plate, make sure both posts fit into slots on the back of phone. Then
push down to lock phone onto wall plate.
11
FOLLOW THESE INSTRUCTIONS TO MOUNT THE PHONE ON THE
WALL WITHOUT A WALL PLATE
Follow these instructions to mount the phone on the
wall without a wall plate:
1. Locate a wall stud. If it is possible to utilize a wall
stud for mounting, dry wall expanders or a similar
type fastener is recommended. Consult your local
hardware stores for details.
2. Drill 2 holes 3 15/16" (100 mm) apart.
3. Put a screw into each hole and leave 3/16" (5mm)
of the head exposed to mount the phone (screws
are not included).
4. Connect the straight cord to the phone and jack.
5. Place the TELEPHONE BASE on the 2 mounting
screws and gently push down to lock into place.
WALL MOUNTING
FOR WALL USE PUT
ADAPTOR HERE
Make sure space
between holes is
Drill one hole
Drill one hole
100 mm
IB-PH3235(MS)-WM-E-122203 .p65 12/27/02, 12:44 PM 12