Lexicon Recording Studio - Manual (Page 27)

To set the input of the track to record from the 1-2 USB channels:
1. Click anywhere in the gray area (not on the buttons) of the Track 1 window
(labeled as Audio 01) .
2. In the Inspector, click the IN: box and select IN 1 for the track input source.
3. In the Track 1 window, the Record Enable button should already be red.
If it isn't, click it so that it turns red.
4. In the Track 1 window, click the Input Monitoring button so that it is not
lit.
5. Next, adjust the input gain of the Instrument input To set the input level, strum
the guitar while gradually turning up the Line 1 knob until the Peak LED lights
only occasionally with the loudest signals.
6. To begin recording, click the Record button on the Transport control. Play some
chords or notes on the guitar. When you are finished recording, click Stop, then
Rewind.
Record Button Stop Button
Rewind Button
7. Click the Play button to listen to the track you have just recorded.
Play Button
Recording a Guitar Using the Instrument Input
27