LXI LX7007 - Manual (Page 6)

LX 7007 pro IGC V1.0 Apr.2005
Page 6
1.2.2 MODE selector (rotary switch)
The mode selector is used to change modes of operation. This switch has the highest priority in the system. Whenever
it is operated, a mode change will occur.
1.2.3 UP/DOWN selector (rotary switch)
This rotary switch has a lower priority than the mode selector switch and is active all the time in the selected mode. It is
mainly used for selecting sub menus during navigation and to scroll in the edit menu.
1.2.4 ENTER button
The main function of this key is confirmation, and to start edit procedures.
1.2.5 ESC/OFF button
This is a multifunctional key, which has two main functions. If it is pressed and held for a few seconds, then the
instrument will turn OFF as outlined in para 2.2.1 above.
If a short press is made, then the button has the following functions:
• The display will jump to the menu of the next higher level (in edit only)
• During alpha-numeric input with the cursor active (blinking), ESC confirms the whole line (It is not necessary to
press ENTER few times)
• Some special functions can be activated using ESC as described in subsequent paragraphs
1.2.6 EVENT button
Activates the Event function (see Chapter 3.1.1.2, Flight Recorder)
1.2.7 MC and BAL buttons
Pressing these buttons activates the Mc Cready (MC) and ballast setting as shown below. The value is then changed with
the UP/DOWN-selector. There is no secondary function of these buttons.
1.2.8 ZOOM (rotary switch)
This is a multifunctional rotary switch. While its main function is to change the zoom level in the graphic mode, it can
also be used as follows:
• To select turn points when in the main TP page
• To select task when in the main TSK page
• If an error is made during editing, it is possible to move the cursor back by rotating this knob. This can only be
done if 'editing' is active which is shown by the cursor blinking