Line 6 DIGITAL WIRELESS XD-V75 - Manual (Page 6)

6
Xd-V75 d
igital
W
iReless
Q
uick
s
etuP
Receiver
8 6 7 9 10
1
2
3 4 5
RF BATTERY AUDIO
MUTE
TRANSMITTER
STATUS
PUSH TO SET
XD-
2.4GHz DIGITAL WIRELESS SYSTEM
CH 1:THH12
8:00
ANTENNA A ANTENNA B A OUT
MAIN OUTS
UNBAL BALANCED
B OUT
USB
9VDC IN
1. Antenna A & B Input Connectors (BNC)
2. Antenna A & B Output Connectors (BNC) – to daisy-chain multiple receivers
3. Unbalanced 1/4-Inch and Balanced XLR Audio Output Connectors
4. 9VDC Power Input Connector
5. USB Connector – for firmware updates
6. Transmitter Status LED Displays
AUDIO – lights green to indicate audio signal level, top clip LED lights red to indicate the audio
is clipping
MUTE – lights red when transmitter is muted
BATTERY – lights green, with all lit indicating full transmitter battery; bottom LED turns red
when 1 hour remains, and flashes red when less than 40 minutes remains
RF – lights green to indicate transmitter signal strength/quality; with transmitter off, red lights
indicate interference on that channel
7. LCD Display Panel – main page shows channel, transmitter, battery life, and antenna strength;
display also functions as programming window
8. Edit / Push to Set ROTARY ENCODER – used to change and set receiver parameters
9. Setup Button / Exit Button – used to access setup menus; EXIT returns to main display page;
these buttons are used along with the ROTARY ENCODER
10. Receiver Power Switch
Plug the power supply cable into the receiver and AC power, and connect the antennas. Turn on the
receiver, press the SETUP button, and with the ROTARY ENCODER scroll to SET CHANNEL and
press to select. Scroll to the desired channel and press to select. Press EXIT . Connect with an audio
cable to a mixer or similar. The receiver is ready to use.