Little Wonder Xtra - Manual (Page 11)

NOTE: A built-in automatic centrifugal clutch
disengages the blade from rotating at engine
idle speed. The clutch engages the blade when
the engine speed is increased.
7. Throttle trigger (engine accelerator control)
is operated by pushing down interlock with
thumb and pulling on trigger (Fig. 8).
8. FLOODED ENGINE: (Engine will not
start.) If smoke or fuel comes from exhaust
and engine will not start.
i.
Check that ignition switch is “ON,”
CHOKE LEVER is on RUN position.
ii. Pull starter rope up to 10 times to clear
engine of fuel so it can start.
iii. If engine has excessive fuel that cannot
be cleared by i and ii above, remove
spark plug from engine and from spark
plug terminal, crank engine to clear
excess fuel, wipe and dry spark plug of
all fuel, re-install spark plug and
terminal, and restart as above.
IMPORTANT: After 1 hour of use, tighten all
screws (especially 9 screws around gear case).
Check after every 20 hours of use.
9. To stop motor, push switch slide on throttle
trigger side forward.
Anti-Vibration (AV) Adjustment
Handle nut can be tightened to mark on knob
to obtain best AV effect to reduce handle
vibrations.
During Break-In Period
A factory-new machine should not be run at
high revs (full throttle) without any load. This
avoids unnecessary wear during the break-in
period. As all moving parts have to set during
break-in period, frictional resistances in the
engine are greater during this period. Engine
develops its maximum power after about 5 to 15
tank fillings.
After Finishing Work
Storing for a short period: Keep the unit in a
dry place until you need it again. Do not store
where open flame or electrical machinery is
operating.
Storing for a long period: Drain the fuel tank
and run engine until carburetor is dry.
O
PERATING
I
NSTRUCTIONS
1. The Xtra Edger is very easy and simple to
use. For some people, it may take a few
edgings to become an expert.
2. Thoroughly inspect the area where the
edger is to be used and remove all stones,
sticks, wires and other foreign objects.
3. Adjust blade height (Fig. 10). With a
new blade, try the second hole closest
to operator.
11
WARNING
Only operate unit when moving forward.
DO NOT operate walking backwards,
as you may trip, fall and injure yourself.
▲
!
▲
!
WARNING
TO AVOID PERSONAL INJURY,
NEVER CARRY THE EDGER WHILE
THE ENGINE IS RUNNING.
Stay clear of the rotating blade.
Stop the engine prior to making
adjustments and cleaning.
▲
!
▲
!
FIG 10