Lucent Technologies 6 - Manual (Page 17)

Checking the Modem Settings
Issue 1 CRCS R6.0 April 1999 13
5. Choose the following settings:
n Connector=Com1
n Baud Rate=9600
n Data Bits=8
n Stop Bits=1
n Parity=None
n Flow Control=None
6. Click the OK button to save the changes. If you are using the 8400B data
module, continue to step 7. For the 7400B data module, skip to step 10.
7. Type ats24=001 to set the data module for standalone operation without a
telephone.
8. Remove power from the 8400B data module for 5 seconds.
9. Reconnect power to the 8400B data module. The red LED comes on
steady.
10. Type at and press Enter. The OK prompt appears. Type atdt and the dial
number you recorded earlier. Press Enter. The login prompt appears.
Figure 9. Connection Description Window