Lanzar Car Audio 440PSU - Manual (Page 6)

5 6
1.12V Constant Power Lead (red): This is the main power input for the
Vibe 440PSU and must be
connected to a (+)12V constant power supply. DO NOT connect this to a switched 12V source or
the system may pop when the key is turned off.
2.Remote Turn-On Input Lead (Blue): This is the input for turning on the
Vibe 440PSU and system
amplifiers. It should be connected to the (+)12V remote turn on output of the system head unit. The
Vibe 440PSU has a built in turn off delay to prevent turn-off pops. When the remote turn on signal
from the head unit shuts off, the amplifiers will turn off immediately and the
Vibe 440PSU will stay
on for five seconds before turning off. This feature is designed into the
Vibe 440PSU to eliminate
system turn off pops that can occur when several components turn off at the same time. DO NOT
connect this to a (+)12V constant power supply.
3.Ground (black): Connect this terminal to a quality ground location, preferably the chassis of the
head unit, which must itself be properly grounded to the vehicle chassis. It is not recommended
that the factory radio ground be used for after-market audio components.
5.SOURCE Input: These are the pre-amp stereo RCA audio inputs to be connected to the source
unit's front pre-amp outputs.
6.AUX Input: These are the pre-amp stereo RCA audio inputs to be connected to secondary source
unit, or auxiliary device's pre-amp outputs.
8.Front Output: These are the pre-amp stereo RCA audio outputs for sending the audio signal to the
front speaker amplifier.
9.Rear Output: These are the pre-amp stereo RCA audio outputs for sending the audio signal to the rear
speaker amplifier.
5.
Controls (Rear Panel)
INPUT
AUXILAIRY SOURCE
INPUT
REAR FRONT
7 9
B+ (Red)
GROUND (Black)
REMOTE (Blue)
(Green)
(Green/White)
(Gray/White)
(Gray)
4
8
7.Sub Out: These are the pre-amp RCA audio outputs for sending the audio signal to the
subwoofer amplifier.
4. High level connection cables: Most aftermarket audio head unit have RCA (low-level) outputs.
Plug the RCA output from the source unit into the RCA input of the
Vibe 440PSU. If your
audio source unit does not have RCA outputs, the
Vibe 440PSU has the capability to accept high
level (speaker level) inputs.