Linksys WIRELESS-G WVC54G - Manual

A Division of Cisco Systems, Inc.
®
Model No.
Quick Installation
Model No.
Wireless
WVC54G (EU/UK)
Internet Video Camera
Wireless- G
1 2
A
Attach the antenna.
B
Connect the included Ethernet
network cable to your router,
switch, or computer.
C
Connect the other end of the
cable to the Ethernet port on
the Camera.
D
Connect the included power
adapter to the Power port on
the Camera.
E
Plug the power adapter into
an electrical outlet.
The Ready LED flashes while
the Camera is initializing. When
the Camera is ready for setup,
the Ready and Ethernet LEDs
are solidly lit.
F
Enter a unique name for the
Camera in the Camera Name
field, and complete the
Description field. Select your
time zone, and enter the date
and time. Then click Next.
G
If your network has a router or
other DHCP server, select
Automatic Configuration-
DHCP. If the Camera requires a
static IP address, keep the
default setting, Static IP
address.
Click Next.
H
If you selected Automatic
Configuration-DHCP in step G,
then proceed to step I.
If you selected Static IP
address, the IP Settings screen
will appear. Enter an IP
Address, Subnet Mask, and
Default Gateway appropriate
for your network. You must
specify an IP Address and
Subnet Mask. If you are unsure
about the Default Gateway,
then leave this field blank.
Complete the Primary DNS
and/or Secondary DNS fields.
Enter at least one DNS address,
which you can obtain from
your ISP. Click Next.
A
H
C
G
A
Insert the Setup CD-ROM into
your CD-ROM drive. The Setup
Wizard should run
automatically, and the
Welcome screen should
appear. If it does not, click
Start and then Run. In the field
provided, enter D:\wvc54g.exe
(if “D” is the letter of your CD-
ROM drive).
B
Click Setup to begin the setup
process.
C
Make sure the Camera is
properly connected to your
network. Click Next.
D
The screen will display a list of
Wireless-G Internet Video
Cameras on your network and
status information. In the
Selection box, click the name
of the Camera you are
currently installing. Click Next.
E
A verify password screen will
appear. In lowercase letters,
enter admin in the
Administrator Name and
Password fields. Click OK.
NOTE: The default IP address of the
Camera is 192.168.1.115.
NOTE: If you want to connect the
Camera to a wireless network for
setup, refer to the User Guide on the
Setup CD-ROM for instructions.
IMPORTANT: You MUST connect the
Camera to a router, switch, or PC* using
an Ethernet network cable BEFORE
powering on the Camera. Otherwise, the
Camera will not function.
D
C
D
E
Connect the Camera to a Wired
Network for Setup
Set up the Video Camera
Package Contents
• Wireless-G Internet Video Camera
• Camera Desktop Stand
• Detachable Antenna
• Power Adapter
• Ethernet Network Cable
• Setup CD-ROM with User Guide
• User Guide on CD
• Quick Installation Guides
• Sololink DDNS Free Trial Card
F
* If connecting the Camera directly to a PC, Linksys recommends that you
use an IP address of 192.168.1.x (x can be any number from 1-254, but
cannot be the same as another device on your network).
NOTE: If your LAN IP address is
different than 192.168.1.x, you
may get an error message when
you configure the camera through
your PC. Ignore the error message.
GHz
2
802.11g
4 ,