Lifetime 125 - Manual (Page 4)


Opt. 2.1: Remove the four Lower Roof Panels and two Center Roof Caps
(leave Skylights in place) that are highlighted below.
Opt. 2.2: Remove all screws from the highlighted Wall Panel that connect it to adjoing Wall Panels
and to the Wall Support.
**Save all hardware for re-assembly!**
ATTENTION: If your existing shed is anchored to the ground, remove all
anchoring hardware before following these steps.
Option 2: Add Extension Kit to an Existing Shed
Note: Your shed may be shorter than shown above. Skip the very back Roof Panels (slightly more nar-
row than the middle Roof Panels) and then remove the next two Roof Panels from each side of the shed
(along with the connected Roof Caps).
Repeat Steps 2.2 through 2.4 for both sides of the shed.
Remove
this panel.
Remove
this panel.