Lindy 21515 - Manual (Page 8)

User Manual KVM Terminal LCD
15
2-21 Brightness
The main menu item "Brightness" is used to adjust the brightness
of the panel. A slider with current brightness value is displayed.
The range of brightness adjustment value is 0 to 255.
B R I G H T N E S S
0 126 255
2-22 EXIT
Exit the menu and save.
EXIT EXIT
YES NO
RadioFrequency Energy, Certifications
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (AUG 2002)
Shielded cables must be used with this equipment to maintain compliance with radio frequency
energy emission regulations and ensure a suitably high level of immunity to electromagnetic
disturbances.
European EMC directive 89/336/EEC
CE statement
This equipment complies with the requirement for
CE mentioned in the European Directive and
Standards EN55022 and EN55024.
This equipment has been tested and found to
comply with the limits (for a class B computing
device) in accordance with the specifications in the
European Standard EN55022. These limits are
designed to provide reasonable protection against
harmful interference. This equipment generates,
uses and can radiate radio frequency energy and if
not installed and used in accordance with the
instructions may cause harmful interference to
radio or television reception. However, there is no
guarantee that harmful interference will not occur in
a particular installation. If this equipment does
cause interference to radio or television reception,
which can be determined by turning the equipment
on and off, the user is encouraged to correct the
interference with one or more of the following
measures: (a) Reorient or relocate the receiving
antenna. (b) Increase the separation between the
equipment and the receiver. (c) Connect the
equipment to an outlet on a circuit different from
that to which the receiver is connected. (d) Consult
the supplier or an experienced radio / TV
technician for help. FCC Compliance Statement (United States)
This equipment has been tested and found to comply
with part 15 of FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful
interference.
This device must accept any interference received.
Including interference that may cause undesired
operation.
Canadian Department of Communications RFI
statement
This equipment does not exceed the class B limits for
radio noise emissions from digital apparatus set out in
the radio interference regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de
bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la
classe A prescrites dans le règlement sur le
brouillage radioélectriques publié par le ministère
des Communications du Canada