Lyngdorf Audio DP-1 - Manual (Page 3)

3
Connecting
When connecting the DP-1s, always connect ”+” and ”-” from the amplifi er to the corresponding ”+”
and ”-” terminals on the DP-1 input. Connect your BassDirect speakers the same way to avoid phase
errors.
Spikes
After the initial placement of the speaker, you might consider using the supplied metal point spikes to give
them optimal support. To fi x them on, we recommend that you gently lay the speaker on one side and screw
in all four spikes together. Before you do this, however, be sure to place a couple of thick towels or similar
underneath the side of the speaker. This will prevent accidental scratching to the surface of the speaker.
After screwing in the spikes, gently bring the speaker to its vertical position. Once upright simply adjust the
spikes to give optimal support. Using the spikes will give the very best support and sound quality. If you want
to spare your fl oor surface from being punctured however, you can use the supplied rubber spikes instead.
Whichever option you choose, avoid “walking” the speakers if you need to move them to a different
position… especially on hard wood fl oors!
RoomPerfect
If you have a Lyngdorf product with RoomPerfect you can now run the program.
Cleaning
Please use a dust-free cloth to clean the speakers. It is also possible to use a slightly damp cloth for more
stubborn marks.
Under no circumstances should you use any kind of cleaning agent on, or in close proximity to, these
speakers.
Specifi cations
Product DP-1
High frequency driver 1” Soft Dome
Woofer/midrange driver 6.5”
Crossover frequency 2.2 kHz
Frequency response 300 - 22 kHz
Sensitivity (2.83V/1m) 89dB
Nominal Impedance 4 Ohm