Lexicon MC-12 Digital Controller Lexicon MC-12 - Manual (Page 59)

SETUP
MC-12
3-17
S-VIDEO OSD 4:3 ON, OFF
Controls the on-screen display aspect ratio when the display device
is connected to a Main Zone S-video output connector. Aspect
ratio refers to the size of the picture or the display device screen. A
4:3 aspect ratio is almost square. A 16:9 aspect ratio, often referred
to as widescreen, is almost twice as wide as high.
When ON is selected, the on-screen display appears in a 4:3 aspect
ratio regardless of the incoming video input signal. When OFF is
selected, the on-screen display appears in the same aspect ratio as
the incoming video input signal.
Note:
When a 16:9 (widescreen) display device is connected
to a Main Zone S-video output connector, the
on-screen display will appear horizontally stretched
across the display device screen if the S-VIDEO OSD
4:3 parameter is set to OFF and an anamorphic video
input signal is present.
S-VIDEO OSD 4:3 MAIN ADVANCED DVD1 INPUTS SETUP
COMPONENT OSD ON, OFF
Controls the appearance of the on-screen display when the display
device is connected to the Main Zone component video output
connector. When ON is selected, the on-screen display appears as
a 480i video input signal on a full blue-screen background. To
minimize viewing distractions, the two-line status does not appear
on the on-screen display. When OFF is selected, the on-screen
display – including the two-line status – is not available.
Note:
When the display device is connected to the Main
Zone component video output connector, the
on-screen display automatically deactivates when
the ON-SCREEN DISPLAY menu BACKGROUND
parameter is set to OFF.
COMPONENT OSD MAIN ADVANCED DVD1 INPUTS SETUP
When the ZONE2 or RECORD IN parameter is set to DIGITAL
or ANLG, the MC-12 recognizes some dts-encoded sources
as audio signals (not data signals) and outputs loud digital
noise from the Zone 2 or Record Zone audio output
connectors.
CAUTION
ZONE2 & RECORD IN DIGITAL, ANLG, DMIX
Control the interaction of the digital and analog audio input
connectors assigned for the selected Zone 2 and Record Zone
inputs. The table on the next page describes ZONE2 and RECORD
IN parameter setting.
RECORD IN OR ZONE2 IN DVD1 INPUTS SETUP
. . . Configuring Advanced Input Settings continues on page 3-18