La Crosse Technology WS-9210U - Manual (Page 14)

14
IV. ALARM FUNCTION
A. SETTING THE ALARM (alarms 1 and 2)
Note: There are two alarms that can set. Each alarm will sound for a
complete duration of 2 minutes.
1. Press and hold the “AL1” button for 5 seconds or until the alarm-
time display flashes in the DATE LCD.
2. Press and release the “IN” button to set the alarm hours, press and
release the “OUT” button to set the alarm minutes.
3. Press the “AL1” button or wait 15 seconds for the unit to
automatically confirm the alarm time and return to display the date in
the DATE LCD as normal.
4. The ((1)) icon, appearing in the DATE LCD, indicates that the alarm
is set to sound at the programmed time.
5. Programming the alarm time automatically activates the alarm to
sound at the programmed time. To deactivate the alarm, press the
“AL1” button (removing the ((1)) icon from the screen). To
reactivate the alarm, press the “AL1” button again.
6. After each activation or deactivation, the programmed alarm time is
displayed. Wait 15 seconds and the date will display in the DATE
LCD again.
7. To set, activate and deactivate alarm 2, follow the directions above
for alarm 1—using the “AL2” button instead of the “AL1” button.
The ((2)) icon will represent activation and deactivation of Alarm 2.
B. SNOOZING AND STOPPING THE ALARM
1. The snooze function is activated by pressing any one of the following
buttons: “SET”, “IN”, “OUT” or “SNZ”.
2. To turn the alarm off completely, press any of these buttons: “CH”,
“AL1”, “AL2” or “DATE”.
3. The snooze function will last for 5 minutes before the alarm begins to
sound again. Either the ((1)) or the ((2)) icon will flash during the
snooze mode.
V. ADDING OUTDOOR REMOTE CONTROL SENDERS (OPTIONAL)
The WS-9210U is able to receive signals from 3 different remote temperature
sensors. The remote temperature sensor model(s) that you choose will come with