Liebherr CI16 - Manual (Page 11)

O
PERATION
6 CI 16/CS 16
To increase the temperature:
Press the UP button on the left to increase
the refrigerator temperature (Fig. 1, 8) and
on the right to increase the freezer
temperature (Fig. 1, 2).
1. While you are entering the temperature, the set
temperature will flash on the display.
2. When you press the temperature setting buttons
for the first time, the most recent setting (known
as the
“reference setting” ) is displayed.
3. You can change the settings in increments of
1°F (1°C) by briefly pressing the buttons again. If
the buttons are held down the temperature
setting will change faster.
4. Approximately five seconds after the button has
been released, the display will automatically
show the actual freezing or cooling temperature
(known as the
“actual setting”).
5. You can change the temperatures:
• In the refrigerator – between 36°F and 44°F
(2°C and 7°C) and
• In the freezer – between -15°F and 6°F
(-26°C and -14°C).
Childproof Lock - Figure 1
The childproof lock is designed to protect the
appliance from being turned OFF accidentally.
1. Turning ON: Hold down the Alarm button
(Fig. 1, 5) and then press the Superfrost button
(Fig. 1, 4). Keep both buttons pressed
simultaneously for approximately three seconds.
• A double beep confirms your entry.
• The Childproof Lock Display (Fig. 1, 6) will come
ON.
2. Turning OFF: Press this key combination again;
the display (Fig. 1, 6) will now turn off.
Temperature Display - Figure 1
In normal operation, the following settings will be
displayed:
• the average refrigerator temperature in
display (Fig. 1, 7)
• the warmest frozen food temperature in
display (Fig. 1, 1).
When starting up for the first time or when the
appliance is warm, dashes will appear until the
temperature reaches a level that can be displayed;
32°F to 66°F (0°C to 19°C) in the refrigerator and
below 32°F (0°C) in the freezer.
It will take between three and eight hours for the
required temperature, 0°F or 41°F (-18°C or 5°C) to
be reached and displayed permanently in the
display, depending on the ambient conditions and
the temperature setting.
The display will flash:
• if you change the temperature or
• if the temperature rises by several degrees,
indicating cold loss, e.g. if you place fresh,
“
warm” food in the freezer or if you remove or
repack frozen food, the temperature may rise for
a short time due to warm air flowing into the
freezer.
• If “F1” to “F5” appears in the display, the
appliance has a fault. Have the fault number
available when you contact the customer service
department.
Audible Warning Signal - Figure 1
The audible warning signal helps to protect frozen
food and to save energy.
• The audible warning will sound when it is
not cold enough in the freezer
compartment.
• The temperature display will also “flash” when
too much warm air enters the freezer
compartment when inserting, rearranging or
removing frozen food.
• The audible warning signal can be turned OFF
by pressing the Alarm button (Fig. 1, 5). The
temperature display will continue to
“flash” until
the cause of the alarm has been corrected.
CI_16_CS_16 Use Manual.qxd 1/12/2004 3:08 PM Page 6