Lyngdorf Audio TDAI 2200 - Manual (Page 26)

2 6
Line Out
The sub menus accessible in the ‘Line Out’ menu are:
Line Out Control
The Line Out Control sets the output level to be Full Scale (fi xed) or regulated.
Fixed means there’s a constant full scale output – most often used as ‘tape out’ or when using a
Lyngdorf Audio TDAI or SDAI as a ‘slave’ amplifi er in a bi-amping set-up.
Regulated means that the output level will follow the level of the volume control. This setting is chosen
if you have, for instance, a power amplifi er or an active subwoofer connected.
Line Out Level
This adjusts the overall output level in steps of - 0.1 db, it can be adjusted up to – 40 db in total.
Routing
In Routing it is possible to apply different settings to the Main and Line outputs:
Symbol Name Main output Line Output
R
L
Highpass fi lter X X
R
L
Lowpass fi lter X X
R L
L R
Left and Right channel switching X -
M Mono - X
M Mono lowpass fi lter - X
A highpass and lowpass fi lter can be applied to the Main and Line outputs when you want to connect an
additional amplifi er or subwoofer together with your main loudspeakers.
A Mono setting is also available for the Line output, this is used when connecting a single subwoofer to
just one Line output.
If no fi lter is selected the full frequency range will be directed to your main loudspeakers. If a fi lter is
selected the frequencies above or below the selecter crossover frequency will be directed through the
analog line-out and digital output terminals.
When a highpass or lowpass fi lter has been chosen, the Crossover Frequency and Filter Type menus are
enabled.
Line Out
Line Out Control Line Out Level
If Full Scale is selected you will constantly have full output – with huge potential for
overload and damage of power amplifi er and/or loudspeakers if connected.