Lindy ATA-133 - Manual (Page 4)

- 4 -
1. As the BIOS boots, press F3 to enter the raid bios utility.
2. Select Create RAID set. Press F2.
3. Select Create Mirrored set press F2.
4. Press Y Select automatic Setup.
5. Press Y and then press ESC to exit the setup.
6. Continue with conventional Fdisk and Format steps as if you are installing
a conventional hard drive.
7.Your RAID configuration is complete. Please proceed to software installation
section.
3.3. Creating a Mirrored-Striped Set
1. As the BIOS boots, press F3 to enter the raid bios utility.
2. Select Create RAID set. Press F2.
3. Select Mirrored-Striped set then press F3.
4. Select Auto config. Press A.
5. Press Y and then press ESC to exit the setup.
6. Continue with conventional Fdisk and Format steps as if you are installing
a conventional hard drive.
7.Your RAID configuration is complete. Please proceed to software installation
section.
3.4. Deleting RAID Sets
1. As the BIOS boots, Press F3 to enter the raid bios utility.
2. Select Delete RAID set. Press F1.
3. Select 1 click Y to remove the RAID set. If the RAID set being deleted is a
Striped set, then all of the data will be lost. If the set being deleted is a
Mirrored set, then the data will remain intact and accessible on both drives.
3.5. Creating a Spare Drive
1. As the BIOS boots, Press F3 to enter the raid bios utility.
2. Select Delete RAID set. Press F1.
3. Answer 1 Select Y to remove the RAID set. If the RAID set being deleted is
a Striped set, then all of the data will be lost. If the set being deleted is
a Mirrored set, then the data will remain intact and accessible on both
drives.
3.6. Deleting a Spare Drive
To delete a spare drive, use the same procedure as deleting a RAID set.