Listen Technologies LT-800-150 - Manual (Page 11)

7
LT-800 Setup Instructions
Coax antenna connection.
Rear of LT-800 shown.
LA-132 Remote Antenna
See RF Reception Maximization
Strategies and Coaxial Cable on
page 13.
1
2
3
Unpack the Product
Remove outer packaging and plastic cover. Inspect for physical damage.
Mount in Rack (if necessary)
If rack mounting the unit, install the optional rack mount kit (part LA-326) according to the
instructions included with the kit, then install the LT-800 in the rack.
NOTE: If rack mounting, you will need to use a rear connection antenna.
Rack Mount with single unit installed
Shown with LT-800
Rack Mount with dual unit installed
Connect Power
Plug the power supply into the power connector on the
back panel, then plug the power supply into an outlet. Only
use a Listen approved power supply (The LA-207, an in-line
switching power supply, is the approved power supply for this
unit).
Connect Antenna
Connect the antenna (not included) according to the installation
instructions. Only use an antenna supplied by Listen. If you are
connecting the antenna directly to the top of the LT-800, you will
need to remove the rubber plug on top of the unit. If you are using
a remote antenna connected to the rear of the unit, do not
connect an antenna to the top connector. See page 19 for
antenna options, or refer to the Listen website for remote antenna
options, www.listentech.com.
rubber plug
LT-800 shown with top mount
antenna connected through top of
unit (part number LA-134)
4
12 VDC 1.3 A