Lanier MERIDIAN G SERIES G08 User Manual
Page 2
MATERIAL SAFETY DATA SHEET
Page
2
of
3
CP-771
Section 6: Accidental Release Measures
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix
AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal
injury. Remove residue with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
Section 7: Handling and Storage
Special Handling:
Cleanse skin after contact before breaks or meals, and end of workday.
Do not handle in areas where the wind blows.
Minimize the breathing of dust.
Special Storage:
Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.
Eye Protection: none required under normal use. Skin Protection: none required under normal use.
Section 9: Physical and Chemical Properties
CHARACTERISTICS:
Appearance: Cyan
Melting
point:
N/a
Form: Powder
Vapor
pressure:
N/a
Odor: Slight
plastic
odor Vapor
density:
N/a
Solubility in Water:
Insoluble
Evaporation rate:
N/a
Specific gravity:
~ 5 g/cm
3
Boiling point:
N/a
Section 10: Stability and Reactivity
Conditions to avoid: none
Hazardous decomposition products: will not occur
Polymerization: none
Section 11: Toxicological Information:
Ames test:
negative
Acute oral toxicity: > 5000mg/kg
Carcinogenicity: no data is available on this product.
Teratogenicity: not available
Section 12: Environmental / Ecological Information
Bioaccumulation: Not known in bioaccumulation
Environmental degradation: not known
Section 13: Disposal Consideration
Used developer should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal
regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for
disposal. Do not incinerate loose or spilled developer.