Lopi Direct Vent Freestanding Stove - Manual (Page 46)

46
Optional Equipment
(for qualified installers only)
Travis Industries 1 0 0 - 0 1 1 8 7 _ 0 0 0 4 0 7 0 2 1 9
Cast or Stone Inserts
WARNING : Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
1 Lift the stove top and place it upside down on a smooth, non-scratching surface. Install the stone
inserts into the stove top following the directions below. Replace the stove top and face to finalize the
installation.
Phillips
Screwdriver
Place the stone inserts into the indents on the
stove top. Attach with the clips and screws.
NOTE: slide the inserts inwards as
far as possible to prevent them from
striking the sides of the cast body.
These clips are for the linenfold,
marble, & granite inserts.
These clips are for the
soapstone inserts.
Note: On the Fyrestone the clips and screws are shipped with the stove in the owner’s pack.
Note: The granite stones may be slightly thin. This leads to the clips not securing the stones in
place. Before installing, use a hammer or pliers to slightly bend the clips downwards. This will
hold the granite tightly against the stove top.