Land Rover DEFENDER LT77S - Manual (Page 33)

...
. .
. ...
...
MANUAL GEARBOX
6. Press fifth gear synchromesh assembly to
mainshaft using 18G 1431.
CAUTION: Before pressing the assembly
locate in the baulk ring slots.
fully home, ensure that the slipper pads
Part number Thickness
FRC 5284
FRC 5286
FRC 5288
FRC 5290
FRC 5292
FRC 5294
FRC 5296
FRC 5298
FRC 5300
FRC 5302 5.64
7. Fit the thinnest washer and secure with circlip.
8. Measure clearance between circlip and washer,
9. Tighten layshaft stake nut using 18G 1205.
CAUTION: The practice of locking gears
not acceptable due t o high torque figure
to provide a restraint to tighten the nut is
required.
NOTE: Only limited movement of the
synchromesh inner member on the
main-shaft is permissable. The maximum
clearance is to to
and t o achieve this the following
selective washers are available.