Lucent Technologies LULCST - Manual (Page 11)

Installation 2-3
2. Set the option switch on the Call Stacker (see Figure 3-1 on page 3-2) for the
desired system configuration (refer to Table 2-1).
NOTE: When the switch
#7 is “OFF”, there
will be no delay in time
from when the paging
system zone is
accessed until the time
when the message is
sent. When the switch
#7 in “ON”, there will
be a 2 second delay
from when the paging
system/zone is
accessed until the time
when the message is
sent. The delay is
installed in order for a
Confirmation/
Pre-announcement
tone (if available or
optioned) to be played
over the system before
the message is sent.
3. Connect the Call Stacker to the paging system (see Figure 2-4):
■ Connect the Call Stacker's Page Output to the attendant override (attendant
access control leads) or incoming alarm signal from the paging system.
NOTE: PBX and KTS
stations must have the
ability to send a
forward disconnect to
the Call Stacker's
Station inputs. ■ Connect one or more of the Call Stacker's Input Station channels to PBX/KTS
analog station inputs on the telephone system through FCC/DOC approved
modular jacks.Connect the Call Stacker's Page Output channel to the paging
system as shown in Figures 2-4 and 2-5 through an FCC/DOC approved modular
jack. The control contact signal is used to secure and release the paging system
controller (see figure 2-3).
Table 2-1. Option Switch Setting.
SET
SWITCH
# 1 TO
SET
SWITCH
# 2 TO
SET
SWITCH
# 3 TO
SET
SWITCH
# 4 TO
SET
SWITCH
# 5 TO
SET
SWITCH
# 6 TO
SET
SWITCH
# 7 TO
Number of DTMF Digits in Zone Code
0 ON ON — — — — —
2 OFF ON — — — — —
3 ON OFF — — — — —
4 OFF OFF — — — — —
Voice Prompts
None — — ON ON — — —
English only — — OFF ON — — —
Spanish only — — ON OFF — — —
English/Spanish — — OFF OFF — — —
Length of Recording Cut Off (when user hangs up during recording)
None — — — — ON ON —
0.25 sec — — — — OFF ON —
0.50 sec — — — — ON OFF —
0.75 sec — — — — OFF OFF —
Confirmation or Pre-Announcement Tone
2 Second Delay — — — — — — SEE NOTE