Lenoxx Electronics PH-549 - Manual (Page 8)

1. USING BATTERIES
GETTING STARTED
3. Replace the battery door and snap it shut (FIG. 3).
Step 2: Powering the Phone
Before you connect the phone cords, follow these steps to install the batteries:
1. Insert a flat blade screwdriver or coin like a quarter into the slot and pry out (lift) the
battery door (FIG. 1).
2. Insert 4 size “AA” alkaline batteries as shown inside the battery compartment (FIG. 2).
CAUTION
Replace the batteries when the low battery indicator
appears on the display.
• When the batteries are dead, the display will not show. You can still make or receive calls,
but you can’t use the Caller ID or memory dialing.
• When the batteries are dead, your data and settings could be erased.
6
FIG. 1 FIG. 3
2. USING AC OUTLET POWER
(AC Adaptor is optional, not included)
This phone may be powered from any household 120V AC outlet using a 6V AC adaptor
(not included). Insert the adaptor’s small connector plug into the DC 6V Jack marked
on the rear of the phone, and plug the adaptor into an AC outlet.
CAUTION:
To prevent electric shock, do not use the AC Adaptor with an extension cord or outlet,
unless it can be fully inserted without exposing any part of the blades.
NOTE: If the AC Adaptor is connected, and regular batteries are installed, the phone
automatically switches to the AC Adaptor power and the batteries are not used.
OPTIONAL
AC ADAPTOR
FIG. 2
PH-549042100RTTv.2 E