Lionel Trains 71-8340-250 - Manual (Page 23)

TrainMaster Command Control operations
Building a lash-up
T rainMaster Command Control allows you to couple your Command Control-equipped
locomotives together, forming a multiple unit lash-up. Just like with the real railroads,
lash-ups allow you to pull longer trains and climb steeper grades. You will find that the lighting
operates prototypically—the lead unit’s headlight and interior lights are illuminated when the
train is in forward, and the rear unit’s headlight and interior lights are on when the train is in
reverse. For more information, refer to your TrainMaster Command Control manual.
To build a lash-up, assign a unique engine (ENG) ID# to each unit. Arrange the units on
the track and couple them together. The Command reverse unit must be set to RUN/FORWARD.
If you press a wrong button, start over with that particular unit. The assignment isn’t
saved until you press SET.
Start with the lead (front) unit
1. Press TR and enter your lash-up ID# (1-9) on your CAB-1 Remote Controller. No other lash-
up or track should share this ID#.
2. Enter the unique ID# of the lead unit.
3. Press F.
4. Press SET on the CAB-1 Remote Controller.
Complete the lash-up by adding the rear unit
1. Press TR and enter the lash-up ID# (1-9) on your CAB-1 Remote Controller.
2. Enter the unique ID# of the rear unit.
3. Press R.
4. Press SET on the CAB-1 Remote Controller.
You are now ready to operate your locomotive as a lash-up. Simply press TR and enter the
lash-up ID#, then use your CAB-1 Remote Controller to operate your locomotives. To operate an
individual unit within the lash-up, press ENG and enter the ID# for that particular unit.
23
Note!