Logic Controls LK7000 - Manual (Page 11)

8
PROGRAMMING THE LK7000 KEYBOARD
The following procedure will show you how to program your LK7000
with standard (keyboard) alphanumeric characters. The keyboard can
be programmed with either ASCII or Scan code information. The default
mode is the ASCII code mode. The following procedure assumes both
a
LK7000 keyboard and a 101 keyboard are attached.
NOTE: To run this program you must exit windows completely.
Do not shell out from Windows.
1. With the correct programming graphics present. Select the cell
you want to program by using the arrow keys on the 101 keyboard.
The Up and Down arrows will select the row while the Shift and
either the Right or Left arrow key will select the column.
2. Enter your programming text via the 101 keyboard. Continue
programming until all the keys are programmed. It is not necessary
to program all the keys for the
LK7000 to function properly. The
maximum number of alphanumeric characters that can be
programmed for any one key is 256.
NOTE: The maximum number of alphanumeric characters that
can be programmed per standard
keyboard is 1856.
3. Press F2 to call up the Data Transfer Menu. There will be
several choices to choose from.
4. Type W to write the programmed data into the LK7000 ’s non
volatile memory. A “Writing Data” screen will open showing the
percentage of memory written. It will take approximately 7 seconds
to copy the data into the keyboard.
Dos shell
File list (*.tpl)
Load file from disk
Read from
keyboard
Save file to disk
Write to
keyboard
Press ESC to Quit
DATA TRANSFER MENU