LOREX Technology LW2100 - Manual (Page 15)

Setting up the Wireless Receiver
11
Setting up the Wireless Receiver
To connect the wireless receiver to a surveillance recorder (DVR):
1. Screw the antenna onto the top of the receiver.
2. Connect the BNC connector on the receiver directly into an available video input.
NOTE: If necessary, attach the 3ft (1m) BNC/BNC extension cable at one end to the receiver and
at the other end to the surveillance recorder.
3. Connect the power cable from the receiver to the Power Adapter; plug the Power Adapter to
an outlet or surge protector.
To connect the wireless receiver to a TV or VCR:
1. Screw the antenna onto the top of the receiver.
2. Attach the included BNC/RCA adapter to the BNC connector on the receiver and plug the
receiver directly into an available video input.
NOTE: If necessary, attach one end of the 3ft (1m) BNC/BNC extension cable to the receiver and
at the other end attach the BNC/RCA adapter, and then connect the BNC/RCA adapter to the
viewing/recording device.
3. Connect the Black power cable from the receiver to the cable of the Power Adapter; plug the
Power Adapter to a local AC power outlet or surge protector.
NOTE: Use the included BNC/BNC extension cable in case the receiver is not able to properly connect
into the viewing/recording device due to space constraints at the back/front of the device or to clear
obstructions between camera and receiver which can affect wireless signal strength.
ATTENTION : Make sure to first connect and power on the camera(s) before powering on the receiver; this will
ensure a proper connection.
Figure 2.0 Attach the receiver directly to an integrated system, TV, or DVR